Table of Contents
Advertisement
> Tap «Alter Stitch Type/Stitch Density».
> Adjust the stitch density (1).
Checking the Size and the Position of the Embroidery Design
It can be checked whether or not the embroidery design matches the designated position/location on the
fabric. Points which are beyond the embroidery hoop are not traveled to.
> Select the embroidery design.
> Tap «i-Dialog».
> Tap «Check Embroidery Design Size».
check
– The embroidery hoop travels all the way until the needle is at the position as it is indicated in the
display.
> To select the desired corner of the embroidery design, tap the respective arrow.
– The embroidery hoop travels all the way until the needle is at the position as it is indicated in the
display. If the embroidery design hasn't been positioned correctly yet, the position can be altered via
the «Upper/Lower Multi-function knobs» and the complete embroidery positions can be checked
again.
> To position the needle in the center of the embroidery design, tap «Center of Embroidery Design».
> Turn the «Upper Multi-function Knob» to move the embroidery design horizontally.
> Turn the «Lower Multi-function Knob» to move the embroidery design vertically.
Endless Embroidery
When embroidering a trim, it is advantageous to use the Mega Embroidery Hoop (optional accessory) or the
Maxi Embroidery Hoop (optional accessory). The embroidering project therefore does not have to be re-
clamped as frequently. We recommend marking guide lines on the fabric and using the pattern when
clamping and re-clamping in the hoop. In doing so, the guide lines must run parallel to the pattern. The
following example, the supplied Oval Hoop is used.
> Select the embroidery design.
> Tap «i-Dialog».
1
Creative Embroidering
147
Advertisement
Table of Contents
