> Tap «Centering the Needle to the Embroidery Hoop».
P
> Thread the upper thread.
> To move the hoop back to its previous position, push the button «Start/Stop».
Move Hoop to the Back
To facilitate changing the bobbin, it is recommended to move the hoop to the back before threading. This
makes it easier to open the bobbin cover.
> Tap «Hoop Indicator/Select Hoop».
> Tap «Move Hoop to the Back».
P
> Thread the bobbin thread. (see page 46)
> To move the hoop back to its previous position, push the button «Start/Stop». If necessary, pull back the
upper thread.
Moving the Module for the Sewing Mode
The embroidery module can be positioned so that any sewing projects can be carried out even if the module
is connected.
> Tap «Hoop Indicator/Select Hoop».
> Remove the hoop.
> Tap «Move Hoop to the Left».
P
> Tap «Home».
> Tap «Sewing Mode».
Grid On/Off
When the center of the hoop and the grid are displayed, the embroidery design can be positioned more
exactly.
> Tap «Hoop Indicator/Select Hoop».
> To show the hoop center on the display, tap «Grid On/Off».
> To show the grid lines, tap «Grid On/Off» again.
> To hide the hoop center and the grid lines, tap «Grid On/Off» again.
Locating the Center of the Embroidery Design
The embroidery hoop is positioned so that the needle is exactly above the center of the embroidery design or
the motif begin.
> Tap «Hoop Indicator/Select Hoop».
> To position the hoop so that the needle is placed exactly over the center of the embroidery design, tap
«Center of Embroidery Design».
> To position the hoop so that the needle is placed exactly over the motif start, tap «Center of Embroidery
Design» again.
Virtual Positioning of the Embroidery Hoop
The embroidery hoop is automatically moved to the new position as soon as the embroidery design is
repositioned. Therefore, the icon «Virtual Positioning» is activated automatically and outlined in yellow when
an embroidery hoop is attached.
Embroidery preparation
139