Table of Contents
Advertisement
> Tap «Factory Setting».
> Tap «Deleting USB Stick» and confirm.
Calibrating the Buttonhole Foot #3A
The Buttonhole Foot with Slide #3A is calibrated to the machine and they should only be used both together.
Prerequisite:
•
The Buttonhole Foot with Slide #3A is fitted.
•
The needle is not threaded.
> Tap «Setup Program».
> Tap «Machine settings».
> Tap «Maintenance/update».
> Tap «Calibrating the Buttonhole Foot #3A».
> To start the calibration, push the button «Start/Stop».
–
When the calibration is complete, the result is shown in the display.
Packing the embroidery module
To pack the embroidery module into the original packaging without moving the embroidery arm manually,
the embroidery arm needs to be brought to its packing position.
Prerequisite:
•
The embroidery module is connected with the machine.
> Tap «Setup Program».
> Tap «Machine settings».
> Tap «Maintenance/update».
> Tap «Packing Position».
> Follow the instructions on the display.
Reviewing the total number of stitches
The total number of stitches by the machine and the number of stitches since the last maintenance carried
out by a specialist BERNINA dealer are displayed.
> Tap «Setup Program».
> Tap «Machine settings».
> Tap «Information».
> Tap «Machine Data».
Setup Program
59
Advertisement
Table of Contents
