Table of Contents
Advertisement
Care and Maintenance
17 Care and Maintenance
17.1 Firmware
Checking the firmware version
The firmware and hardware versions of the machine and the connected embroidery module are displayed.
> Tap «Setup Program».
> Tap «Machine settings».
> Tap «Information».
> Tap «Machine Data».
Updating firmware
The machine's current firmware and detailed step-by-step instructions for the update process can be
downloaded from www.bernina.com In general, personal data and settings are automatically transferred
during a firmware update. For reasons of safety, it is also recommended to save data and settings on a
BERNINA USB stick before the firmware update is started. If personal data and settings should get lost during
a firmware update, they can be transferred to the machine again afterwards.
Prerequisite:
•
> Insert the USB stick with the new firmware version into the machine.
> Tap «Setup Program».
> Tap «Machine settings».
> Tap «Maintenance/update».
> Tap «Updating firmware».
UPDATE
> To start the firmware update, tap «Update».
Update
Recovering saved data
If personal data and settings after a software update are not available anymore, they can be transferred to
the machine again afterwards.
> Insert the BERNINA USB stick providing the saved data and settings into the USB port of the machine.
> Tap «Setup Program».
> Tap «Machine settings».
168
Accessories such as the Embroidery module or the BSR Foot which are connected to the machine have
been removed.
Please note: The update can take several minutes. During the update, do not switch the machine off
and do not remove the USB stick.
–
The machine restarts. Once the update is complete, a message appears.
Advertisement
Table of Contents
