Table of Contents
Advertisement
Embroidery preparation
> Fit the hoops into each other so that the material does not move.
> Hoop the fabric tautly in the embroidery hoop.
> Tighten the screw.
> Remove the template from the hoop by using the template holder.
> To avoid scratches on the free arm, press the inner hoop into the outer hoop so that the inner hoop
Attaching the Hoop
> Raise the needle.
> Raise the embroidery foot.
> Hold the hoop with the right side of the fabric up with the attaching mechanism to the left.
> Position the hoop below the embroidery foot.
> Press both attaching mechanisms (1) of the hoop towards each other.
> Position the embroidery hoop (2) above the bracket of the embroidery arm.
> Press the hoop down until it clicks in position.
> Release the attaching mechanism (1).
> Press the attaching mechanisms of the hoop towards each other to remove the hoop.
> Remove the hoop.
Overview Embroidery functions
1
2
3
Centering the Needle to the Embroidery Hoop
Relocating the embroidery hoop facilitates threading when the needle is close to the embroidery hoop.
> Tap «Hoop Indicator/Select Hoop».
138
including the fabric protrudes downwards by up to 1 mm.
2
1
1
«Centering the Needle to the Embroidery
Hoop»
«Move Hoop to the Back»
«Move Hoop to the Left»
1
2
3
4
5
6
4
«Grid On/Off»
5
«Center of Embroidery Design»
6
«Virtual Positioning»
Advertisement
Table of Contents
