Lubrication - PRONAR PDK220 Operator's Manual

PRONAR PDK220

5.6 LUBRICATION

Machine lubrication should be performed with the aid of a manually or foot operated grease
gun, filled with generally available permanent grease. Before commencing lubrication insofar
as is possible remove old grease and other contamination. Remove and wipe off excess oil
or grease
When using the machine the user is obliged to observe lubrication instructions
according to attached schedule. Excess lubrication substance causes depositing
additional contaminants in places requiring lubrication, therefore it is essential to keep
individual machine elements clean.
Gear oil in cutter bar and intersecting axis gear should be changed according to
recommendations contained in section 5.2 CUTTING UNIT MAINTENANCE
TABLE 5.3 LUBRICATION POINTS AND LUBRICATION FREQUENCY
ITE
NAME
M
Suspension rotation system
1
pin
Drive transmission bearing
2
pin
3 Intersecting axis gear
Intersecting axis gear
4
rotation sleeves
5 Cutter bar
Surface of multi-splined
6
drive shaft
7 PTO shaft *
Description of designations in "ITEM" column (TABLE 5.3) matches the numbering in (FIGURE 5.6)
*- For detailed information on maintenance please refer to operator's manual attached to the shaft.
NUMBER
TYPE OF
OF
LUBRICATI GREASE
ON POINTS
1
1
1
SAE 90EP
2
1
SAE 90EP
1
*
5.14
LUBRICATION
FREQUENCY
grease
grease
gear oil
grease
gear oil
grease
*
SECTION 5
20 hours
20 hours
500 hours
20 hours
500 hours
20 hours
*