Table of Contents
Advertisement
PRONAR PDK220
First oil change should be made after 50 hours mower operation and then, after each 500
hours of operation or at least once in the season, whichever occurs first. 2.4 litres of
SAE90EP (80W90 GL5) gear oil can be poured into cutter bar. It is best to change oil
immediately after completing work when cutter bar is still hot and impurities are suspended in
oil. Cutter bar has two drain plugs (2) on both sides. You may use either drain plug (2) to
drain oil, depending on the oil change method.
In order to change oil in cutter bar:
• unscrew filler plug,
• raise cutterbar,
• unscrew drain plug and drain oil to previously prepared basin,
• tighten drain plug,
• position cutting unit horizontally and pour the required quantity of oil through the
opening of inspection filler plug,
Oil in cutter bar must be changed after the first 50 hours of work. The next oil change
should be made after 500 hours of work or once a year, whichever occurs first.
TIP
To lubricate cutter bar, use 2.7 litre of transmission oil SAE90EP (80W90GL-5). Oil level
should be 6 ÷ 8 mm above the bottom of the cutterbar.
If a leak is noticed, carefully inspect seals and check oil level. Mower operation with low oil
level in cutter bar may cause lasting damage. Repairs of cutter bar during warranty period
(except blade replacement) may only be performed at authorised mechanical workshops.
DANGER
Do NOT perform service or repair work under raised and unsupported machine.
Check oil level in intersecting axis gear daily before beginning work.
5.6
SECTION 5
Advertisement
Table of Contents
