Cutting Unit Service - PRONAR PDK220 Operator's Manual

SECTION 5 PRONAR PDK220

5.2 CUTTING UNIT SERVICE

Service of cutting unit involves periodic inspection and change of oil in cutter bar and in
intersecting axis gear.
FIGURE 5.3 Checking and change oil in cutter bar
(1)- inspection filler plug; (2)- drain plug; (A)- correct oil level in cutter bar 6÷8 mm from
bottom of bar
Correct oil level (A) with cutter bar in horizontal position is 6 ÷ 8 mm from the cutter bar
bottom. To check oil level, unscrew inspection filler plug (1) located between the second and
third disks counting from the gear. In the case of cold oil after lowering the bar to horizontal
position, wait approximately 15 minutes before checking.
Check oil level in cutter bar daily before beginning work.
5.5