Connecting Of Pto Shaft - PRONAR PDK220 Operator's Manual

SECTION 4
FIGURE 4.11 Setting cutting height
(1) - cutter bar; (2) - top link (central link); (B) - cutter bar inclination of 4º÷5º against ground
Adjust length of top link (2) so that cutter bar inclination angle (B) (in the mowing direction)
o o
should be 4 to 5 . Lengthen top link to increase cutting height. Shorten top link to reduce
cutting height.

4.5.3 CONNECTING OF PTO SHAFT

DANGER
Before connecting the shaft, turn off the tractor engine and remove the key from the
ignition. Ensure that unauthorised persons do not have access to the tractor.
The use of PTO shaft and its technical condition must be in accord with the Operator's
Manual of PTO shaft.
Before connecting the mower it is absolutely necessary to carefully read the Operator's
Manual attached by the Manufacturer of the shaft and observe the instructions contained in it.
IMPORTANT!
Before first use, adjust the length of PTO shaft according to Operator's Manual of PTO
shaft recommendations.
4.15
PRONAR PDK220