Table of Contents
Advertisement
PRONAR PDK220
FIGURE 5.4
Checking and change of oil in intersecting axis gear
(1) - inspection plug (2) - filler plug with air vent, (3) - drain plug (A) - correct oil level
TIP
To lubricate intersecting axis gear, use transmission oil SAE90EP (80W90 GL-5).
The correct oil level should reach the lower edge of the inspection plug opening (when
the cutter bar is set horizontally)
Used oil should be taken to the appropriate facility dealing with the re-use of this type of
waste.
If a leak is noticed, carefully inspect seals and check oil level. Transmission operation with
insufficient oil may cause permanent damage of the mechanism.
Repair of transmission during warranty period may only be performed at authorised
mechanical workshops.
5.8
SECTION 5
Advertisement
Table of Contents
