PRONAR PDK220 Operator's Manual page 67

SECTION 5
To check the oil level in intersecting axis gear:
• set cutter bar horizontally,
• unscrew inspection plug (1) (FIGURE 5.4),
• oil level should reach the lower edge of the plug opening (1),
• if necessary, supplement oil to the required level.
DANGER
When checking oil level and changing oil, use the appropriate personal protection
equipment i.e. protective clothing, footwear, gloves eye protection. Avoid contact of skin
with oil.
Oil in intersecting axis gear must be changed after the first 50 hours of work. The next oil
change should be made after 500 hours of work or once a year, whichever occurs first.
To change oil in intersecting axis gear:
• set mower level horizontally,
• unscrew inspection plug (1) and drain plug (3) (FIGURE 5.4),
• drain oil into the previously prepared vessel and tighten drain plug (3),
• if oil Manufacturer recommends flushing transmission, that operation should be
performed according to the guidelines of the oil Manufacturer (guidelines may be
detailed on packaging),
• pour oil through plug (2) to lower edge of inspection filler plug opening.
• screw in filler plug (2) and inspection plug (1).
5.7
PRONAR PDK220