PRONAR PDK220 Operator's Manual page 26

PRONAR PDK220
• The machine may only be connected to the tractor by appropriately selected PTO
shaft recommended by the Manufacturer.
• The PTO shaft has markings on the casing, indicating, which end of the shaft
shall be connected to the tractor.
• Never use a damaged PTO shaft, it may cause an accident. A damaged shaft
must be repaired or replaced.
• Disconnect the drive shaft each time when it is not necessary to drive the
machine.
• The chains preventing the shaft cover from turning while the shaft is working,
shall be secured to a fixed element of machine structure.
• Do NOT use the securing chains to support the shaft while machine is parked or
when transporting the machine.
• Before using the machine, the user should thoroughly acquaint himself with the
PTO shaft Operator's Manual and adhere to the recommendations contained in it.
• The drive shaft must be equipped with a cover. Do NOT use the shaft with
damaged or missing guards.
• After connecting shaft ensure that it is correctly and safely connected to the
tractor and to the mower.
• Before starting the machine make sure that there are no bystanders (especially
children) in the danger zone. The machine operator is obliged to ensure proper
visibility of the machine and the working area.
• Before starting PTO shaft make certain that the PTO rotation direction is correct.
• Before disconnecting the shaft, turn off the tractor engine and remove the key
from the ignition.
• Do NOT wear loose clothing, straps or whatever that may become wrapped round
the rotating drive shaft. Contact with rotating PTO shaft may cause severe
injuries.
• Do NOT go over and under the shaft or stand on it equally during work as also
when the machine is parked.
2.8
SECTION 2