PRONAR PDK220 Operator's Manual page 47

SECTION 4
FIGURE 4.3 Transport position
(A), (B), (C)- transport positions
To set the mower in (C) position:
• Lift the mower on three-point linkage
• release and take out securing pin (2), from safety catch (FIGURE 4.5)
• raise safety catch (1) and place in bracket frame and secure with pin (2) and
cotter pin (FIGURE 4.5)
• manually tilt whole cutting unit backwards until it locks in that position;
• close lifting cylinder valve (2) (FIGURE 4.4)
In (C) transport position the mower can be transported only short distances at an
appropriately reduced travel speed.
Three point linkage lower arms must be secured so that mower does not swing sideways.
DANGER
During transport of the mower mounted on the tractor, the cylinder valve (2) (FIGURE
4.4) should be set in position "0 – closed"
4.9
PRONAR PDK220