Work Of Mower; Operation Of Pto Shaft - PRONAR PDK220 Operator's Manual

SECTION 2
• In order to reduce the danger of fire the machine must be kept in a clean
condition.

2.1.6 WORK OF MOWER

• Before lowering or lifting the mower mounted on the three-point linkage, make
sure there are no bystanders, especially children, near the machine.
• Before starting mower drive, the cutting assembly must be in working position.
• Before starting the mower make sure that there are no bystanders (especially
children) or animals in the danger zone. The machine operator is obliged to
ensure proper visibility of the machine and the working area.
• Mowing should begin after reaching nominal PTO RPM of 540 rpm. Do NOT
overload shaft and mower and also do NOT engage the clutch suddenly.
• During cutting do NOT use PTO revolution speed greater than 540 rpm.
• When mowing on the edges of streets, public roads, on stony ground there is a
risk that thrown out stones and foreign bodies may pose a risk to bystanders and
other vehicle passing by.
• Do NOT operate mower without guards in place.
• Do NOT leave the tractor cab, when the machine drive is engaged.
• Do NOT stand within the mower's working zone.
• Do NOT approach cutting unit guards until the rotating cutting parts come to a
complete standstill.
• Do NOT operate mower while reversing. While reversing raise the multifunction
arm.
• Do NOT lift cutting unit before cutting discs come to a complete standstill.
• Keep a safe distance from electric power lines during travel with raised cutting
assembly.

2.1.7 OPERATION OF PTO SHAFT

• While reversing and during turns, the PTO drive must be disengaged.
2.7
PRONAR PDK220