Kyocera 3508ci Operation Manual page 571

Troubleshooting > Troubleshooting
Message
Cannot read data in
this ID card.
Cannot recognize.
Cannot staple at the
specified position.
Cannot staple this
*1
paper.
Cannot staple this
*1
paper size.
Cannot staple this
*1
paper type.
Cannot use ##### due
to a failure.
Cannot use following
functions due to
scanner failure.
>> Copy, Send, Fax,
Storing in Box
Cannot use this
function due to a hard
disk failure.
Check the document
processor.
Check the paper in the
multipurpose tray.
Check the side feeder.
Check the staple
waste box.
Checkpoints
―
―
Have you selected a position
that cannot be stapled?
Did you select a paper size/type
that cannot be stapled?
―
―
—
Is the top cover of the document
processor open?
Is the document processor
open?
—
—
Is the staple waste box full?
—
10-35
Corrective Actions
In registration process, the ID
card information was not read
correctly. Hold again the ID card
over the ID card reading part.
If the same message still
appears, the
ID card may not be compatible
with this product. Change it to
another ID card.
Make sure your ID card has
been registered.
If the selected paper is not
changed and [Continue] is
selected, staple is released.
Select the available paper.
Select [Continue] to print.
If the selected paper is not
changed and [Continue] is
selected, staple is released.
Select the available paper.
Select [Continue] to print.
Call service.
Scanner of this machine has
failed. Contact your service
representative. You can use the
print function.
Call service.
Close the document processor
cover.
Close the document processor.
The paper size is different. Set
selected size paper and select
[Continue].
The side feeder is not installed
correctly. Attach the side feeder.
Follow the instructions on the
screen, and empty the staple
waste box.
The staple waste box is not
installed correctly. Set it
correctly.
Reference
Page
―
―
page 6-30
page 6-30
―
―
—
―
―
page 5-6
―
page 10-14
page 10-14