Winter Storage - Taylor SLIM7 Operator's Manual

OPERATOR CHECKLIST
Note: For machines equipped with an air filter, it will be
necessary to vacuum clean the filters on a monthly
schedule.
WARNING! Always disconnect electrical
power prior to cleaning the condenser. Failure to follow
this instruction may result in electrocution.
 If your machine is equipped with an auxiliary
refrigeration system, check the auxiliary
condenser for accumulation of dirt and lint. A dirty
condenser will reduce the refrigeration capacity of
the mix hopper. Condensers must be cleaned
monthly with a soft brush. Never use
screwdrivers or other metal probes to clean
between the fins. Failure to comply may result in
electrocution.
 If your machine is water-cooled, check the water
lines for kinks or leaks. Kinks can occur when the
machine is moved back and forth for cleaning or
maintenance purposes. Deteriorated or cracked
water lines should be replaced only by a Taylor
service technician.
7
7-2

Winter Storage

It is recommended that a Taylor service technician
perform winter storage draining, to ensure all water has
been removed. This will guard against freezing and
rupturing of the components.
If the place of business is to be closed during the winter
months, it is important to protect the freezer by following
certain precautions, particularly if the building is subject
to freezing conditions.
Important! On water-cooled freezers, disconnect the
water supply. Relieve pressure on the spring in the water
valve. Use air pressure on the outlet side to blow out any
water remaining in the condenser. This is extremely
important. Failure to follow this procedure may cause
severe and costly damage to the refrigeration system.
Your local Taylor distributor can perform this service for
you.
• Disconnect the freezer from the main power source
to prevent possible electrical damage.
• Wrap detachable parts of the freezer (such as the
beater assembly and freezer door) and place them in
a protected, dry place. Rubber trim parts and gaskets
can be protected by wrapping them with 
moisture-proof paper.
• All parts should be thoroughly cleaned of dried mix or
lubrication accumulations, which can attract mice
and other vermin.
Model 0736
Operator Checklist