Taylor SLIM7 Operator's Manual page 38

OPERATING PROCEDURES
10. Insert the liquid regulator into the hole located on the
bottom of the pump cover, aligning the notch with the
retaining pin. Rotate to lock in place.
6
11. The regulator can be adjusted to six available
positions to achieve the desired overrun.
6-6
Figure 6-24
Figure 6-25
Figure 6-26
Feed Tube Assembly
1. Slide one feed tube O-ring into the groove on the
bushing and lubricate.
Note: Make sure the valve is properly seated in the
tube. Do not lubricate the duck-bill valve.
2. Slide the additional feed tube O-rings into the
grooves on the feed-tube and lubricate them.
Insert the duck bill valve into the feed tube until it
slides in place in the groove.
Model 736
Figure 6-27
Figure 6-28
Operating Procedures