Taylor SLIM7 Operator's Manual page 51

Problem
14. The barrel walls are
scored.
15. The product makes a
popping sound when
drawing product.
Troubleshooting Guide
Probable Cause
a. Missing or worn beater auger.
b. Missing or worn scraper blades.
c. Missing or worn counter beater.
d. The machine was placed in Auto
mode before all sanitizing solution
was removed from barrel.
e. Beater assembly is bent.
f. Counter-beater assembly is bent.
a. Pump assembled incorrectly.
b. Air/mix pump incorrectly seated.
c. Draw rate is set too fast.
d. Barrel not primed correctly.
Model 0736
TROUBLESHOOTING GUIDE
Remedy
a. Install or replace the beater head.
b. Install or replace the scraper blades.
c. Install or replace the counter beater.
d. Place machine in Auto mode only
after priming is complete and all
sanitizing solution is removed.
e. Replace beater assembly.
f. Replace counter-beater assembly.
a. Assemble and lubricate according to
instructions in this manual.
b. Check and if necessary, change the
position of the regulator tube to a
position with greater liquid flow (turn it
to the left).
c. Adjust draw rate.
d. Drain the barrel and prime the
machine.
Page
Ref.
6-1
6-1
6-1
5-2
6-1
6-1
6-4
- - -
- - -
6-8
8
8-3