Basic Safety Instructions; Electrical Connection - ADVANCED UV LIGHT ICON Owner's Manual

Basic Safety Instructions

Electrical connection

■ Observe all safety instructions attached to the equipment and provided
in this manual.
■ Take care that only trained and authorized personnel handles this
sunbed.
■ Only trained and authorized personnel is allowed to transport,
assemble, start and disassemble this unit. Authorized and trained
personnel is limited to:
- service staff of Advanced UV Light or its authorized
distributors
- electrical personnel who due to their expertise and training
have the necessary know-how for proper handling and the
necessary knowledge of related risks.
■ Avoid all actions which may contain a safety risk.
■ Prior to performing any of the jobs listed below, the unit must be
completely cooled down and disconnected from the mains supply:
- transport
- disassembly
- maintenance jobs
- cleaning of UV lamps
- cleaning of HID lamps
The following conditions must be fulfilled at the site of installation for fault-
free operation of the unit:
■ wire gauge of mains supply cable and fusage must comply with
technical data
■ installation of a mains supply disconnection switch
■ installation of an FI-protective switch
■ installation of a time-controlled device which shuts off the unit after 30
minutes (automatic safety switch off)
■ disconnection of the unit from the mains supply and secured against
reconnection with lock and key whenever performing any of the
following jobs:
- repair work
- maintenance
- cleaning of UV lamps
- cleaning of HID lamps
■ no liquids enter into the sunbed.
If any liquids have entered the sunbed
- disconnect the unit immediately from the mains supply and
secure with lock and key against reconnection.
- have the unit checked by certified electrical service
personnel prior to restarting the unit.
6