Basic Safety Instructions; Electrical Connection; Safety Provisions; Operation - ADVANCED UV LIGHT ELIXIR Owner's Manual

Basic Safety Instructions

• Observe all Safety Instructions attached to the sunbed
and provided in this manual.
• Only authorized and skilled personnel is allowed to
transport, assemble, start-up and disassemble the
sunbed.
• Service personnel of Advanced UV Light GmbH and
its authorized distributors' are considered as trained
staff with the necessary expertise. This also includes
skilled electrical personnel who due to their training and
practical expertise provide appropriate handling and
service and who are aware of all potential dangers.
• Avoid any use or handling that may incur certain risks.
• Transportation, disassembly, assembly, maintenance
and cleaning (i.e. of low-pressure lamps) must only be
performed after the unit has completely cooled down.

Electrical Connection

• Operation of the sunbed is only allowed if the unit is
connected and secured on the site in compliance with
the technical requirements stated on the type label and in
accordance with local electrical standards.
• Operation of the sunbed is only allowed, if a mains
disconnection switch.
• Ensure that liquids ( i.e. cleaning solutions) do not get
into the sunbed. Stop the mains supply immediately by
activating mains disconnection switch and secure it with
lock and key in case any liquids have entered into the
sunbed.
• Prior to performing any jobs on the sunbed, i. e.
transportation, assembly, disassembly, maintenance
and cleaning the mains supply must be switched off. In
addition, the mains disconnection switch must be secured
with lock and key against unauthorized or accidential turn
on.

Safety Provisions

• Use the sunbed only when in fault-free technical
condition. All protection and safety devices must be
assembled and in working condition.
• Use the sunbed only with installed front cover plate.
• All DANGER-labels and notices must be immediately
replaced when damaged.
• Do not use the sunbed with defective filters or timer.
ORIGINAL DR. MÜLLER HIGH PERFORMANCE TANNING EQUIPMENT
7
Suitable Site of Installation
• Do not install the sunbed in damp rooms or in rooms
where there is a risk of explosions.
• Do not keep or store any containers with explosive
materials, i. e. spray cans, close to the sunbeds.
• Smoking and open flames are prohibited within proximity
of the sunbed.
• Do not expose materials that may suffer damage from
UV-light exposure to the UV-rays emitted from this
sunbed.

Operation

• Do not cover or block ventilation (i. e. air entry) or
cooling devices to avoid potential thermal damages.
• Before or after each use, check the sunbed for obvious
outer damages or defects and eliminate immediately.
• Defects which may affect the safe operation of the sunbed
must be communicated immediately to the responsible
person in charge on the owner/operator' s behalf.
Discontinue the use of the sunbed until all of these defects
have been removed.

Transportation

• All devices used for transportation must be adequate to
the weight of the sunbed.
• All applicable standards and regulations to prevent
accidents at the work-place must be observed.
• All paths of transportation must be blocked and clearly
marked to prevent injuries caused by transportation
vehicles or the load.

Cleaning

• Clean and disinfect the sunbed prior to each use. Remove
rests of sanitary foils or other substances.
• Never clean the sunbed with abrasive or corrosive
cleaning materials. Do not use any tools with sharp
edges.

Maintenance

• All maintenance instructions and intervals must be
observed.
• Use only original spare parts as provided by Advanced
UV Light GmbH or its authorized distributors. In any
other case you need authorized service personnel to
approve of these parts being in compliance with technical
specifications as required by manufacturer.
Original Dr. Müller ®