Sample Set-Up - ADVANCED UV LIGHT ICON Owner's Manual

Table of Contents

Advertisement

Example
The following example shows you how to change a set-up. If, for instance,
you want to customize the operating hours for low-pressure lamps, proceed
as follows:
 Turn the mains disconnection switch into position "I".
 Push the following sequence of buttons:
"Cooling top canopy",
"Facials",
"Cooling top canopy",
"AC unit",
"AC unit".
You are now in the operator menue. The operating hours for low-pressure
lamps can be found under menue point "02".
 Push the "Music" button twice.
Menu point "02" is shown.
 With the buttons "+" and "–" you enter the required value for the
operating hours, for instance 500.
 With the "+" button you increase the value shown on the display.
 With the "–" button you diminish the value shown on the display.
 In order to get to the next menu point, push the button "Music", until you
reach the required menu point.
 In order to leave the operator menu, push the "Music", button until you
have reached the last point in the menu.
The set-ups are saved automatically.
In this example, after the low-pressure lamps have reached a total of 500
operating hours, the display will show in the lower right corner a blinking
point which indicates that the pre-set max. operating hours for the low-
pressure lamps have been reached.
44

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ICON and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents