Disassembly Of Sunbed Acrylic - ADVANCED UV LIGHT ICON Owner's Manual

Table of Contents

Advertisement

CAUTION!
Risk of bruises for hands and feet.
Carry the electric ballast tray with two persons to prevent it from falling
from the pallet.

Disassembly of sunbed acrylic

 Loosen the six screws which hold the bracket and remove.
 Pull the electric ballast tray carefully forward.
 Unplug all connection cables and take care that cables do not get
pinched when moving the ballast tray .
 Two (2) strong persons take out the ballast tray and carry it to the site of
installation.
At the front and rear side, across its whole length, the sunbed acrylic sits
in a profile groove. Two sash locks secure the acrylic against unauthorized
opening. The sash locks are turned by an Allan key (6 mm). A safety switch
controls the installation and position of the sunbed acrylic.
Two (2) persons are needed to remove the sunbed acrylic.
 Open the the two sah locks:
Turn clockwise by 90° .
 The acrylic can now be pushed backwards out of the front groove.
-
The safety switch below the acrylic lifts it a bit upwards for
easier handling.
 Lift the acrylic in the front and pull it out of the rear groove.
 Take the sunbed acrylic out, carry it to the site of installation and store
safely for further use.
21

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ICON and is the answer not in the manual?

Table of Contents