Installation Of Lamps Into The Sunbed; Replacement Of Starters; Survey Of Uv Lamps And Starters; Disassembly Of Starters - ADVANCED UV LIGHT ICON Owner's Manual

Table of Contents

Advertisement

Installation of UV-lamps in the sunbed

Replacement of starters

Survey UV-lamps and starters
Disassembly of starter
 Clean the lamps with a soft leather cloth slightly damped in glass
cleaner or clear water.
 Put the UV lamps into the lampholder (3.).
 Turn the lamp clockwise by 90° (4.)and make sure that the lamp stamp
is clearly visible to the viewer.
– The UV-lamp snaps into the lampholder with a „click".
 After all sunbed UV-lamps have been installed, re-assemble the AC
acrylic.
 Lift the sunbed acrylic for a few centimeters..
 Put the acrylic support back into its place.
 Let the sunbed acrylic down onto the sunbed.
Starters must be replace whenever lamps start to flicker or do not light up.
 Disconnect the unit from the mains supply by turning off the the mains
disconnection switch and secure with lock and key against accidental
re-connection.
1
UV-lamp
2
lampholder
3
starter
 If you need to replace a starter, proceed as follows:
 Turn off the mains disconnection switch and secure with lock and key
against accidental reconnection.
 Take the UV-lamp out of the lampholder.
 Turn the starter by 90° counter clockwise (2).
 Take out the starter(1).
58

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ICON and is the answer not in the manual?

Table of Contents