Identification (Ident) - Siemens SITRANS LR460 HART Operating Instructions Manual

Default settings in the parameter tables are indicated with an asterisk (*) unless
Note:
explicitly stated

2. Identification (IDENT)

Operation Unit
Tag
Text that can be used in any way, for example as a unique label for a field device
in the plant.
Descriptor
Text that is associated with the Field Device. This text can be used by the user
in any way. There is no specific recommended use.
Message
Text that is associated with the Field Device. This text can be used by the user
in any way. There is no specific recommended use.
2.1. Configuration (CONFIG) (for HART devices)
Configuration (CONFIG) (for PROFIBUS PA devices) 2.1.
See
PROFIBUS PA devices. Note that menu numbers are different within Configuration
for PROFIBUS PA and HART.
2.1.2. Address (ADDR)
The unique address of the device on the network (HART address).
Values
To set the address via the handheld programmer:
• Press Mode
• Press Down ARROW
navigate to Address.
• Press Right ARROW
flash.
• If required, key in a new value and press Right ARROW
2.1.3. Remote operation enable (REMLOCK)
Enables or disables programming via the network and PDM.
Handheld programmer
Values
2.1.5. Reset
Notes:
• After resetting to factory defaults, complete reprogramming is required.
• Resetting to factory defaults does not clear values in the Quick Start
Wizard: they can be re-applied.
• Performing a Warm Start clears all values from the Quick Start Wizard.
A5E42035355
HART 0 to 15,default: 0
to activate PROGRAM mode, menu item 1.0.
, Right ARROW
to open Edit mode: the PROGRAM icon
0
1
SITRANS LR460 – INSTRUCTION MANUAL
on page 51 to configure
, Right ARROW
*
Remote operation enabled
Remote operation disabled
to
will
to accept it.
Page 49