Siemens SITRANS LR460 HART Operating Instructions Manual page 57

2.1.8. Backlight
Controls the setting for the LCD backlight feature.
Handheld
programmer
Values
2.1. Configuration (CONFIG) (for PROFIBUS PA devices)
Configuration (CONFIG) (for HART devices) 2.1.
See
devices. Note that menu numbers are different within Configuration for PROFIBUS
PA and HART.
2.1.1. Address (ADDR)
The unique address of the device on the network (PROFIBUS address).
Values
To set the address via the handheld programmer:
• Press Mode
• Press Down ARROW
navigate to Address.
• Press Right ARROW
flash.
• If required, key in a new value and press Right ARROW
To set Address via PDM:
Open the menu Device – Set Address.
2.1.3. Remote operation enable (REMLOCK)
Enables or disables programming via the network and PDM.
Handheld programmer
Values
2.1.4. Reset
Notes:
• After resetting to factory defaults, complete reprogramming is required.
• Resetting to factory defaults does not clear values in the Quick Start
Wizard: they can be re-applied.
• Performing a Warm Start clears all values from the Quick Start Wizard.
A5E42035355
0 Backlight off
1 Backlight on
Backlight remains illuminated for 3 minutes from last key
2 *
press.
0 - 126, default: 126 (We recommend a setting in the
PROFIBUS PA
range 1 to 125.)
to activate PROGRAM mode, menu item 1.0.
, Right ARROW
to open Edit mode: the PROGRAM icon
0
1
SITRANS LR460 – INSTRUCTION MANUAL
on page 49 to configure HART
, Right ARROW
*
Remote operation enabled
Remote operation disabled
to
will
to accept it.
Page 51