Setup; Computer Setup; Chair Setup - Interacoustics Micromedical Orion Installation Instructions Manual

3

Setup

This section describes the configuration of computer- and chair setup. It is important to follow the steps of
this section precisely to succeed with the overall installation of the chair.
3.1

Computer Setup

It is expected that a computer running VisualEyes software is installed in the clinic prior to installation of the
Orion Chair. The computer must be configured to meet the requirements of the Pc setup section in
VisualEyes Instructions For Use.
It is recommended that the computer used with the Orion Chair is connected to a powered USB Hub. The
hub will be the terminal for USB data connections amplifying signals to ensure the desired data quality. All
goggles with USB communication delivered by Interacoustics come with an apt USB Hub, which can be used
for Orion chair communication.
3.2

Chair Setup

This section is separated in two parts.
Part one (3.2.1) must be completed, after which the installer should jump to Section 4 of this instruction.
After completing the installation of the chair, the installer can follow the steps of part two 3.2.2 to finalize the
setup of the Orion Chair.
3.2.1 Chair Setup: Part 1 (connections)
The following information guides the installer in connecting the Orion chair to power and data. This is
important to activate the locking mechanism of the chair which is used during anchoring of the chair to the
floor. The following parts must be at hand for the process:
D-0120794-D – 2023/06
Orion Reclining Chair Installation Instructions
Figure 7: Example of computer setup using a 7-port USB Hub
Page 13