Table of Contents
Advertisement
4.5 Placing anchors
Place the anchor into the drilled hole with the expanded end first.
Figure 29: Anchor with expanded end pointing to hole
Insert the split anchor end into the drilled hole. Make sure the anchor is below the concrete surface.
Complete this process for all three anchors. Move the chair back over the anchors.
Stack the lag screw with the washers, first the small steel washer then the large washer, see Figure 30.
Figure 30: Lag screw with washers
Place the screw with washers into the anchor and tighten firmly with a wrench. The lag screw will expand the
anchor in the concrete hole.
If the anchor spins in the hole, remove the anchor, clean out the concrete dust and try again.
D-0120794-D – 2023/06
Orion Reclining Chair Installation Instructions
Page 28
Advertisement
Table of Contents
