Connect Wiring - ETC Echo Relay Panel Mains Feed Installation Manual

Note:
It is best to install any panel option kits after conduit rough-in and load and
control terminations are complete to reduce the likelihood of damage to the option
card.
1. Turn off power to the relay panel.
2. Align the option card to the mounting studs
located on the left side of the relay panel
termination I/O board.
3. Insert the card edge connector into the
receptacle on the relay panel termination I/O
board.

Connect Wiring

The 0–10V Dimming Control option card provides four
bus connections for termination of six 0–10 V outputs
each (24 channels). A pluggable screw-terminal
connector is provided for each bus, and is labeled for
ease of identification of each output. The removable
connectors accept 0.25–4 mm
0–10V Option Card
4. Install one standoff at each corner of the
board.
5. Install the provided protection cover over the
installed board.
6. Secure the ERP-LVD and the protective cover in
place using the four screws provided in the
installation kit.
2
(24–12 AWG) wire.
38