Installation; Mount The Panel - ETC Echo Relay Panel Mains Feed Installation Manual

Chapter 2

Installation

Mount the Panel

The Relay Panel Mains Feed can be surface or flush mounted to the installation location.
1. Determine where your panel will be installed using the details outlined in
Environment
2. Six mounting keyholes are provided on the rear of the panel. You must supply your own 3/8
inch mounting hardware (bolts are recommended). Mark and pre-drill the mounting holes
to the mounting surface using the measured drawing below as a guide.
10.2 cm
(4 in) deep
171.5 cm
(67.5 in)
3. Install the mounting hardware. See
least 25 mm (1 in) of threads exposed for ease of mounting the panel.
17
and Clearance on page 13
ERP 120V
36.6 cm
(14.4 in)
28.4 cm
(11.2 in)
80.3 cm
(31.63 in)
71 cm
(27.9 in)
.
ERP 240/277V
50.8 cm
14.7 cm
(20 in)
(5.8 in) deep
38 cm
(15 in)
171.5 cm
(67.5 in)
Parts and Specialty Tools Required on page 12
Installation
80.3 cm
(31.63 in)
80.3 cm
(31.63 in)
Relay Panel Mains Feed Installation Manual
. Leave at