User Interface Orientation - ETC Echo Relay Panel Mains Feed Installation Manual

User Interface Orientation

When the Relay Panel Mains Feed is mounted with the main breaker towards the bottom of
the panel, you will need to rotate the user interface so the display text is in a readable
orientation. When installed correctly, the display is to the left of the button pad.
1. Remove the four screws securing the user interface to its back box.
The user interface is attached to the backplane with a ribbon cable. This cable is long
•
enough to stay attached during reorientation, but can be removed if preferred.
2. If preferred, disconnect the ribbon cable from the rear of the user interface.
a. Gently pull the locking tabs out and away from the ribbon cable.
b. Pull the cable gently off of the header and tuck it into the back box and out of the way.
3. Pull the user interface out, away from the panel.
4. Rotate the user interface so the LCD screen is positioned to the left of the button pad.
5. If previously removed, reattach the ribbon cable by pressing the connector firmly onto the
header.
Take the connector orientation into consideration when reinstalling the ribbon cable.
•
6. Align the channel in the bracket arms to the metal posts inside the user interface back box.
7. Slide the user interface onto the metal posts and push until the faceplate is flush with the
back box.
8. Reinstall the four previously removed screws.
Prepare for Installation
mounting post
16