Table of Contents
Advertisement
Dimmer
The 300 W dimmer installs in the same manner as a single pole relay. You will need to order
dimmer kits individually or as part of a custom panel.
ERP-DIM
Single-pole, single space 300 W dimmer
•
120 V panels only
•
Forward/reverse-phase dimmed loads (auto-
•
switching)
Note:
DIM-MLV with magnetic loads.
Option Cards Overview
Option cards are available for field installation into the Relay Panel Mains Feed. Each option
adds another level of features and functions to the panel and the installation.
0–10 V Dimming Control
WARNING:
may not be fully isolated from high-voltage AC power. Do not assume that
0–10V wiring is safe to touch, even when run as an NEC Class 2 signal. Test
for AC voltage to ground before terminating any 0–10V control wiring to the
device.
AVERTISSEMENT :
ÉLECTROCUTION! Le câblage 0–10V peut ne pas être complètement isolé du
courant alternatif haute tension. Ne supposez jamais que le câblage 0–10V
peut être touché en toute sécurité, même s'il est utilisé avec un signal NEC
de Classe 2. Testez la tension alternative par rapport à la terre avant de
raccorder tout câblage de commande 0–10V à l'appareil.
Introduction
ETC does not support the use of the ERP-DIM with magnetic loads. Use ERP-
The 0–10 V Dimming Control option card (ERP-LVD) provides 24
outputs for control of 4-wire current-sink, 0-10 VDC
fluorescent or electronic loads.
Each of the 24 outputs are rated to control a maximum of
•
400 mA per channel (up to 50 ballasts per channel).
Loss of power at the Relay Panel Mains Feed controller results
•
in releasing control levels to full.
The ERP-LVD option card installs by card edge connector to
•
the left side of the I/O termination board.
For more information, see
RISK OF DEATH OR INJURY BY ELECTRIC SHOCK! 0–10V wiring
RISQUE DE MORT OU DE BLESSURE PAR
ERP-DIM-MLV
Single-pole, single space 300 W
•
dimmer
120 V panels only
•
Forward-phase dimmed loads
•
0–10V Option Card on page 37
.
8
Advertisement
Table of Contents
