Low-Voltage Wiring Trough - ETC Echo Relay Panel Mains Feed Installation Manual

Low-Voltage Wiring Trough

One low-voltage wiring trough is preinstalled in the Relay Panel Mains Feed. This trough runs
the length of one side of the panel, allowing data and low-voltage cable routing from a top
entry installation. If required, you can move this trough to the opposite side of your panel.
Move Trough to Opposite Side
1. Remove the front covers to gain access to the low-voltage wiring trough. For information
on removing covers, see
2. Remove the four screws holding the trough in place.
3. Rotate the trough 180°.
4. Use the same four screws to reinstall the trough on the opposite side of the panel interior
as shown below.
Panel ships
with trough
located here
15
Installation on page 17
Remove
trough
.
Relay Panel Mains Feed Installation Manual
Rotate 180°
then reinstall
to opposite
side