Cable Routing And Conduit Access - ETC Echo Relay Panel Mains Feed Installation Manual

Cable Routing and Conduit Access

When planning conduit entry and cable routing to the panel, pay special attention to the
following recommendations:
Purpose
Feed wiring
Load wiring
Control wiring
(DMX, Network,
etc.)
0-10V Output
Notes:
Do not install conduit in conflict with the option card locations on the
bottom panel or the low-voltage troughs specific to your installation.
For feed wiring, both copper and aluminum feeds are acceptable. For all
other wiring, use copper wire only.
Note:
Control wiring (DMX, Network, etc.) and power wiring must be run in
separate conduit in accordance with local code.
Prepare for Installation
Top Side
Top Entry
Entry
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Bottom Side
Bottom Entry
Entry
No No
No No
Yes Yes
Yes Yes
14