Table of Contents
Advertisement
EBARA Oil Smart Pump System
Oil Smart
®
Simplex Panel
Testing:
Liquid Smart
®
Alarm Sensor: Fill small cup supplied with oil.
Submerge only the plastic lens (optic sensor) into oil, the alarm will
activate showing oil present (yellow light). Now touch finger to the
exposed stainless steel sensor, the alarm will show water present
(white light) will turn on.
Oil Smart
®
Switch: Place HOA switch on control panel in the auto-
matic position. Place your thumb on the short sensor of Oil Smart®
Pump Switch and the pump will turn on. While touching the short
sensor, touch the long sensor „off‰ with your fingers. Remove your
thumb from on sensor and begin to move your fingers down the off
sensor. Remove your fingers from off sensor and the pump will turn
off. Or fill sump with water, when water reaches on sensor, the
pump will turn on and remain on until water clears the off sensor.
Operation:
When water comes in contact with the short (on) sensor, the pump will
turn on. The pump will remain on until water clear the long (off) sensor.
If oil comes in contact with the on sensor, the pump will not turn on;
however the pump switch will activate and pump water from under the
oil. Oil does not harm the system in anyway.
Preventive Maintenance:
The Oil Smart® Pump and the Liquid Smart Alarm Switches must be
kept clean. If units are submerged in water during initial installation,
the switches must be cleaned. Clean with a rag and household rubbing
alcohol or kerosene. Consistent inspection and preventive mainte-
nance ensures longevity and proper operation of components.
EBARA Pumps Americas Corporation
www.pumpsebara.com
(t) 803 327-5005 • (f) 803 327-5097
ON
OFF
28
rev. 01/14
Advertisement
Table of Contents
