Set Up Hik-Connect - HIKVISION DS-2CD6D44G1H-IZS User Manual

Note
The verification code is required when you add the camera to Hik-Connect service.
6. Save the settings.
Enable Hik-Connect Service via SADP Software
This part introduce how to enable Hik-Connect service via SADP software of an activated camera.
Steps
1. Run SADP software.
2. Select a camera and enter Modify Network Parameters page.
3. Check Enable Hik-Connect.
4. Create a verification code or change the old verification code.
Note
The verification code is required when you add the camera to Hik-Connect service.
5. Click and read "Terms of Service" and "Privacy Policy".
6. Confirm the settings.

8.16.2 Set Up Hik-Connect

Steps
1. Get and install Hik-Connect application by the following ways.
- Visit https://appstore.hikvision.com to download the application according to your mobile
phone system.
- Visit the official site of our company. Then go to Support → Tools → Hikvision App Store .
- Scan the QR code below to download the application.
Note
If errors like "Unknown app" occur during the installation, solve the problem in two ways.
Visit https://appstore.hikvision.com/static/help/index.html to refer to the troubleshooting.
●
Visit https://appstore.hikvision.com/ , and click Installation Help at the upper right corner of
●
the interface to refer to the troubleshooting.
2. Start the application and register for a Hik-Connect user account.
Network Camera User Manual
61