9. Insert the jack handle into the worm shaft
of the jack and turn it counterclockwise
to lower the vehicle.
10.Tighten the wheel hub nuts securely in
the diagonal order across the wheel.
Tightening torque: 9 - 12 kgf-m
(65 - 87 ft-lb, 88.-::> - 117.6 N.m)
11. Install the wheel cover, by lightly tap
ping, aligning the cutout section with the
air valve.
CAUTION
Be careful with the wheel cover grip clips.
May break if improperly installed. Last
two grip clips should be pressed
simultenously during installation.
12. Check the air pressure of the replaced
tire and adjust it as specified.
Tighten the air valve cap.
10-10