Settings; Lcd Backlight; Factory Reset; Info - SHOWTEC Power Spot 9 Q6 Tour Manual

Power Spot 9 Q6 Tour

4. Settings

In this menu you can manually set a few settings.
01) Press the MODE button until the display shows
02) Press the SETUP button to open this menu.
The Power Spot 9 has 2 different setting modes.

4.1. LCD Backlight

01) Press the SETUP button to open menu
02) Press the UP/DOWN buttons to select the desired LCD backlight time.
The Power Spot 9 has 4 different LCD backlight time settings.

4.2. Factory Reset

01) Press the SETUP button to open menu
02) Press the SETUP button to open menu
03) Press the UP/DOWN buttons to confirm the reset.
Reset possibility 2:
To reset the device to its factory default settings, press and hold down the MODE and SETUP buttons for a
few seconds.

5. Info

In this menu you can view the version number of your Power Spot 9.
01) Press the MODE button until the display shows
02) Press SETUP to enter the Software Version Menu
03) Press SETUP to show the version number

6. Auto Mode

In this menu you can set the Power Spot 9 to the auto run program.
01) Press the MODE button on the device, until the display shows
available built-in programs in a sequence. It is not possible to adjust any settings in Auto mode.
Ordercode: 42576
.
.
.
.
.
.
.
16
. The device will now run all the