Meiko UPster H 500 Operating Instructions Manual page 27

Operating Instructions UPster H 500 / H 500S
17.3.4 Resetting the TE degree of depletion display
Press the "Accept" button to confirm.
If the option "Display degree of depletion" is active during operation with partial deminer-
alization cartridges, the counter has to be reset using the function above after the car-
tridge has been changed
You can leave this level by pressing the "0" key again.
17.3.5 First-time-filling of boiler
Press the "Accept" button to confirm.
After emptying the boiler (repair of descaling) it must be filled with water again before the
heater is switched on. This is achieved using this parameterization.
You can leave this level by pressing the "0" key again.
17.3.6 Configuration level
You will find a list of configuration parameters on this level.
(parameter numbers 2xx). You can view and modify the parameters. You can also access
the input and output states, or set outputs for testing.
On the configuration level, you will first see the display below:
this corresponds to the viewing/modifying parameters.
This is equivalent to View/modify parameters (see 17.3.7)
This is equivalent to View input states.
This is equivalent to View/modify parameters (see 17.3.8)
This is equivalent to View and set output states.
This is equivalent to View/modify parameters (see 17.3.9)
Press the "I" key to move forwards or the "II" key to move backwards or the "accept" key
to make a selection. You are now at the current level.
You can leave this level by pressing the "0" key.
9735020 Design and construction subject to change without prior notice!
27 42
Page of