Maintenance, Servicing; Basic Safety Measures During Normal Operation; Dosing Equipment - Meiko UPster H 500 Operating Instructions Manual

Operating Instructions UPster H 500 / H 500S
A functional test on all safety systems of the machine / installation is carried out during
every regular maintenance
We recommend concluding a maintenance contract with our authorised distributor in
CAUTION!
order to ensure a long service life of the warewashing machine.
Cordon off access to the operating area for unauthorised persons before starting
maintenance or repair work. Display a sign drawing attention to the maintenance or
repair work!
CAUTION!
Before implementing any maintenance or repair work the warewashing machine must be
switched off completely via the on-site power disconnection device and secured against
reactivation by using appropriate measures (e.g. via a padlock whose key is in the pos-
session of the person conducting the maintenance or repair work)!
Failure to observe these precautions can result in severe injury or damage to property.
Before maintenance or repair work, make sure that the machine's main cock is turned
off! Check that all lines are securely connected.
CAUTION!
Before maintenance and repair work, ensure that the machine is empty and cool down
the boiler, pipes and washing chamber so that all parts of the machine that may be
touched have cooled down to room temperature!
CAUTION!
Carefully dispose of any cleaning products that could harm the environment!
Before starting operations following maintenance or repair work, all initial tests must be
carried out as described in "Machine Settings for Initial Commissioning by the Service
Engineer".
CAUTION!
For all work on or with the machine, observe legal requirements relating to the avoid-
ance of waste materials and to their recycling/removal!
In particular, during installation, repair and maintenance work, materials that could pol-
CAUTION!
lute water such as: Grease and oils, Cleaning fluids containing solvents, must not pollute
the ground or run into the sewerage system! These materials must be stored, shipped,
collected and disposed of in suitable containers!
9735020
19

Maintenance, servicing

Regular maintenance is a prerequisite for the long-term reliable and safe operation of a
warewashing machine. Maintenance which is neglected or improperly carried out in-
creases the residual risk of unforeseen damage to property and persons, for which no lia-
bility will then be assumed.
Maintenance work should only be conducted if the warewashing machine has been
switched off completely via the on-site power disconnection device.
Existing safety systems must not be removed!

19.1 Basic safety measures during normal operation

Observe the maintenance intervals prescribed in the operating instructions!
Observe the maintenance instructions for the individual components!
19.1.1 Before putting back into operation following maintenance or
repair work
19.1.2 Observe environmental protection regulations

19.2 Dosing equipment

The dosing units themselves are maintenance free in principle but the working life of the
wearing parts (peristaltic tube) is largely dependent on the chemical used.
Design and construction subject to change without prior notice!
Page
38 42
of