Meiko UPster H 500 Operating Instructions Manual page 10

Operating Instructions UPster H 500 / H 500S
CAUTION!
CAUTION!
CAUTION!
CAUTION!
CAUTION!
CAUTION!
CAUTION!
9735020
Steel scrub pads are not to be used for the pre-scouring nor for cleaning the items to
be washed.
Do not wash any metal items in the warewashing machine which are not made of
stainless steel.
The operator must reliably prevent metal parts (especially iron, tinplate, copper) enter-
ing the machine.
The machine must not be used to transfer waste water from other sources into the
drain (Warning: risk of corrosion and blockage).
Only use suitable products for cleaning the stainless steel surfaces. They must not
attack the material, form any deposits, or cause any discolouration.
The hood must be closed!
There must be no body parts between dishwashing machine hood and dishwashing
machine tank as the hood is being closed.
Open the hood very carefully during the programme cycle, as otherwise wash water
could splash out.
The tank heating element may still be hot after the tank has been emptied. As a result,
there is a risk of burns or scalding when cleaning the machine manually!
Wear suitable work clothing
Loose clothing and jewellery increases the risk of being caught on protruding parts.

Wear tight-fitting work clothing. Wear trousers down or an apron.

Do not wear rings, necklaces or other pieces of jewellery.

Wear protective gloves and goggles.
Wear secure, suitable shoes. (We recommend wearing safety shoes with steel toe
caps)
Only use detergents and rinse aids suitable for commercial dishwashing machines.
Please contact the manufacturers of these products für information.
Detergent and rinse aid may contain hazardous substances.
Observe the manufacturers' hazard warnings on the original containers and safety
data sheets.
On completing operation, switch off the warewashing machine completely using the
local circuit breaker.
The accompanying Operating Instructions must be observed for accessory devices,
e.g. water treatment installations.
WE DO NOT ACCEPT NO LIABILITY FOR DAMAGE OR
INJURY ARISING FROM FAILURE TO OBSERVE AND
ABIDE BY THESE SAFETY INSTRUCTIONS!!!!
5.2.1 Working on the electrical equipment
Any repair work and troubleshooting on the machine's electrical equipment must be car-
ried out by a qualified electrician!
Check the electrical equipment regularly! Tighten any loose connections! Replace any
damaged leads/cables immediately!
Design and construction subject to change without prior notice!
Page
10 42
of