Priming; Standard Priming Instructions - ELECTRO FREEZE SLX400C Operator's Manual

ELECTRO FREEZE Soft Serve Models SLX400C
10.2

Priming

Figure 10-3 Mix Feed Tube Assembly

10.2.1 Standard Priming Instructions

1. Place a bucket under the dispense
head.
2. While filling the mix hopper with one
gallon of mix open the plunger by
pulling the dispense handle down
and allow mix to push out remaining
sanitizer. When pure mix is flowing
from the dispense head close the
dispense handle (figure 10-4).
Failure to completely remove sanitizer
or water from the freezing cylinder
before placing in
damage the freezer.
3. Allow mix to continue flowing into the
cylinder until the mix in the hopper
stops bubbling. Insert mix feed tube
assembly. NOTE: Be sure to install
the mix feed tube assembly so that
the arrow is facing the operator to
allow for easier adjustments.
30
Important:
freeze will
Priming the freezer removes all excess
sanitizer from the freezing cylinder,
and sets the proper overrun for the first
cylinder of product.
1. Make sure that your hands, forearms,
and all freezer assemblies are
sanitized.
2. See figure 10-3. Insert the regulator
into the mix feed tube assembly.
Place mix feed tube on sanitized
surface. Set to desired port size
number. Larger holes are for thicker
products. Insert the mix feed tube
assembly into the hopper drain outlet.
3. Proceed to instructions in section
10.2.1 or 10.2.2 depending on freezer
setup.
4. Press the freeze button to start
the freezer.
5. Repeat Steps 1 - 4 for the other side
of the freezer.
6. Sanitize and install nozzles.
Figure 10-4 Pure mix
184582-01