Removing The I/O Spring; Replacing The I/O Spring; Microprocessor; Removing The Microprocessor - Toshiba Infinia 7130 Series Maintenance Manual

Removing the I/O Spring

To remove the I/O spring, perform the following procedure and refer to Figure 4-28.
1. Remove the system board (refer to section 4.9.1.).
2. Pull the I/O spring away from the system board.

Replacing the I/O Spring

To replace the I/O spring, perform the following procedure and refer to Figure 4-28.
1. Align the I/O spring cutouts with the appropriate system board ports.
2. Press the I/O spring into place.
3. Replace the system board (refer to section 4.9.2.).

Microprocessor

This section covers the removal and replacement of the computer's microprocessor.

Removing the Microprocessor

To remove the microprocessor, perform the following procedure and refer to Figure 4-29.
1. Turn off power to the computer, then disconnect the power cord and all external
cables connected to the computer.
2. Remove the system board (refer to section 4.9.1.).
CAUTION: If the system has been running, the heat sink, microprocessor, and
regulator may be hot. Allow a few minutes for cooling. Consider wearing
protective gloves.
Infinia™ Series Maintenance Manual --------------------------------------------------------- 4-153
Figure 4-28 Removing and Replacing the I/O Spring