Toshiba Infinia 7130 Series Maintenance Manual page 108

Procedure 2
Procedure 3
Procedure 4
Procedure 5
Procedure 1
The purpose of this procedure is to determine if a damaged mouse cable or an improper
connection is causing the mouse to malfunction. To perform this procedure, perform the
following Check.
Check (A) Inspect the mouse cable and connector for damage. (B) Replace the mouse if it
is damaged (refer to section 4.14.). (C) Verify that the mouse is correctly
connected to the appropriate port in the rear of the computer. (D) Reboot the
system.
If the message, Mouse Detected displays on the screen during bootup, perform
Procedure 3. If this message does not display on the screen during bootup, perform
Procedure 2.
Procedure 2
The purpose of this procedure is to determine if the mouse is defective. To perform this
procedure, perform the following Check.
Check (A) Replace the mouse with a substitute mouse (refer to section 4.14.). (B) Test to
determine if the problem still exists.
If the problem still exists, perform Procedure 5. If the problem no longer exists,
perform Procedure 4.
Procedure 3
The purpose of this procedure is to determine if the mouse operates properly. To perform this
procedure, begin with Check 1 and continue as instructed.
Check 1 Test the mouse's operation.
If the mouse operates properly, perform Check 2. If the mouse does not operate
properly, perform Procedure 4.
Check 2 Determine if the original problem still exists.
If the original problem still exists, perform the Problem Definition Process. If the
original problem no longer exists, perform the No Trouble Found Process.
Infinia™ 7130, 7160, and 7200 Maintenance Manual ---------------------------------------3-101
Mouse Substitution Check
Mouse Operation Check
Mouse Replacement Check
System Board Replacement Check
Mouse Cable/Connector Check
Mouse Substitution Check
Mouse Operation Check