Replacement Procedures
6. Remove the TP Bracket.
Removing TP Bracket
Install the Touch Pad Module Assembly
The following describes the procedure for installing a touch pad module assembly. (See
Figure 4-16-5 ~ Figure 4-16-6)
1. Set the TP BKT on TOP assembly firmly. Make sure the guide pin (on Top assembly)
insert into guide hole (on TP BKT) properly.
2. Secure the TP BKT with the following screws.
• M2.0×2.5-I (BNI)(NYLOK) D7 T0.3 IRON Screw
Guiding Structure
Figure 4-16-5 Secure the TP BKT with the following screws
Satellite L830 Maintenance Manual (960-Q08)
Figure 4-16-4 Removing TP Bracket
x2
49