Toshiba Infinia 7130 Series Maintenance Manual page 197

Primary Input Device Not
Found
Secondary IDE Controller
Resource Conflict
Serial Port 1 Resource Conflict
Serial Port 2 Resource Conflict
Static Device Resource Conflict
Motherboard Device Resource
Conflict
C.3. BIOS Error Messages
Error Message
CH-2 Timer Error
CMOS Checksum Failure
CMOS System Options Not Set
CMOS Time and Date Not Set
Diskette Boot Failure
DMA Error
DMA #1 Error
DMA #2 Error
FDD Controller Failure
HDD Controller Failure
INTR #1 Error
INTR #2 Error
Invalid Boot Diskette
Memory Size Decreased
Parity Error - System Halted
C.4. ISA NMI Messages
ISA NMI Message
Memory Parity Error at xxxxx
Infinia™ 7130, 7160, and 7200 Maintenance Manual ---------------------------------------- D-8
The designated primary input device (keyboard, mouse, or
other, if input is redirected) could not be found.
The secondary IDE controller has requested a resource that
is already in use.
Serial port 1 has requested a resource that is already in use.
Serial port 2 has requested a resource that is already in use.
A non Plug and Play ISA card has requested a resource that
is already in use.
A non Plug and Play ISA card has requested a resource that
is already in use.
Table C-3 BIOS Error Messages
Most systems include two timers. There is an error in timer 2.
After CMOS RAM values are saved, a checksum value is
generated for error checking. The previous value is different
from the current value. Run Setup.
The values stored in CMOS RAM are either corrupt or
nonexistent. Run Setup.
Run Setup to set the date and time in CMOS RAM.
The boot disk in floppy drive A: is corrupt. It cannot be used
to boot the system. Use another boot disk and follow the
screen instructions.
Error in the DMA controller.
Error in the first DMA channel.
Error in the second DMA channel.
The BIOS cannot communicate with the floppy disk drive
controller. Check all appropriate connections after the
system is powered down.
The BIOS cannot communicate with the hard disk drive
controller. Check all appropriate connections after the
system is powered down.
Interrupt channel 1 failed POST.
Interrupt channel 2 failed POST.
The BIOS can read the disk in floppy drive A:, but cannot
boot the system. Use another boot disk.
The amount of memory on the motherboard is less than it
was at the last boot.
Fatal Error has occurred - System halted.
Table C-4 ISA NMI Messages
Memory failed. If the memory l ocation can be
determined, it is displayed as xxxxx.
Explanation
Explanation