Removing The Front Bezel - Toshiba Infinia 7130 Series Maintenance Manual

Removing the Front Bezel

To remove the computer's front bezel, perform the following procedure and refer to Figure 4-
11.
1. Turn off power to the computer, then disconnect the power cord and all external
cables connected to the computer.
2. Remove the right-side panel (refer to section 4.2.1.), rear bezel (refer to section
4.2.3.), and left-side panel (refer to section 4.2.5.), as viewed from the rear.
3. Remove the HDD (refer to section 4.6.1.).
4. On the right-hand side of the front chassis, press down on the bottom tab, press in on
the middle tab, and press up on the top tab.
5. On the left-hand side of the front chassis, press down on the bottom and middle tabs.
6. On the left-hand side of the front chassis, carefully use a screw driver or other
instrument to press in on the top tab.
7. Pull the bezel away from the chassis.
Figure 4-11 Removing and Replacing the Front Bezel
Infinia™ Series Maintenance Manual --------------------------------------------------------- 4-132