Labels - Guardian Fall Protection 00484 Instruction Manual

Labels

BULL RING ANCHOR
Part #: 00484
DOM:
OSHA 1926 Sub M, OSHA 1910,
ANSI Z359.18-2017,
and ANSI A10.32-2012.
PRIOR to use, read
and understand all
manufacturer's instructions
included with the equipment.
Inspect prior to EACH use.
Competent Person must inspect
every 6 months, and record
inspection in instruction manual
and on equipment.
7
Made in China
Serial #:
! WARNING
IMMEDIATELY remove from
service if exposed to forces of fall arrest.
Avoid all contact with sharp and
abrasive edges and surfaces.
Avoid all contact with hazardous
conditions including, but not limited
to, high temperatures, electrical
shock, and corrosive chemicals.
www.guardianfall.com
1-800-466-6385
6305 S. 231st St.
Kent, WA 98032
90003 (Rev. F)
Worker capacity: 130-420 lbs.
Material: Zinc-plated steel
Type A anchorage connector.
5,000 lb. MBS
(minimum breaking strength).
Minimum service temp.: -30° F.
MAXIMUM 1 connection.
All connections must be
compatible with the Bull Ring
Anchor, and selected by
a Competent Person.
INSTALLATION:
Use (5) 1/4" x 3" screws OR
(6) 16d nails. See instructions.
Nail installation compatible
with OSHA standards only.
Fully embed all fasteners
into substrate.
85000 (Rev. L)