Labels - Guardian Fall Protection 10920CSA Instruction Manual

Labels

Serial #
WARNING: Prior to use, fully read and understand
all manufacturer's instructions provided with
equipment at time of shipment.
DO NOT ATTEMPT TO SELF SERVICE OR REPAIR!
DO NOT REMOVE THIS LABEL.
INSPECTION: Prior to each use, inspect device per instructions,
including locking function (sharp pull to test), retraction
function, legibility of labels, evidence of defects, damage, or
missing parts, and condition of connectors, housing, fasteners,
and lifeline (inspect full length). Inspection by
Competent Person required at least every 12 months.
Immediately remove from service if evidence
of shock pack deployment is found.
STANDARDS:
ANSI Z359.14-2014, ANSI A10.32-2012, OSHA 1926
Subpart M, OSHA 1910, & CSA Z259.2.2-2017
J F M A M J J
YR
YR
YR
YR
YR
Assembled in USA
91176 (Rev. A)
1
CSA Compliance Information
Lifeline: 20' Câble, 3/16" width. /
Corde de seécurité: Sangles 20' (6.1m),
largeur 3/16" (4.8mm).
Class SRL / Classe SRL.
Worker mass range: 100-310 lbs. /
Gamme de masse des travailleurs:
100-310 lbs. (45-140 kg).
For use by 1 worker only. /
À utiliser par un seul travailleur.
Maximum arrest force: 1,800 lbs. /
Force d'arrestation maximale: 1,800 lbs. (8kN).
Maximum deployment, SRD overhead: 47". /
Déployment maximum, SRD au-dessus de
la tête: 47" (.51m).
Maximum deployment, with free fall: 102". /
Déployment maximum, en chute libre: 102" (2.6m).
Maximum free fall: 6'. /
Chute libre maximale: 6' (1.8m).
Minimum horizontal offset: 0'. /
Décalage horizontal minimum: 0' (0m).
Favg: 900 lbs. (4kN).
D140. See instructions. /
Voir les instructions.
7
Part #
10920CSA
20' 3/16" CABLE
Lot # Mfg. Date
USE: This device is only for use by one person as a fall
arrester. Only make connections directly to attachment
point on safety harness. Guard against swing-fall by
keeping lifeline vertically overhead. Ensure that connection
to anchorage is secured properly before use. Avoid lifeline
contact with sharp or abrasive edges and surfaces. May be
used as a component of a PFAS in HLL applications. Design,
installation, and utilization of HLLs must be supervised by a
Qualified Person. Suitable for horizontal use. Competent Person
must calculate fall clearance prior to use; fall clearance
calculations must include considerations for swing fall. Clearance
numbers specified based on lifeline installed vertically
overhead and in-line with worker.
SPECIFICATIONS:
Average arresting force: 900 lbs.
(LE Use):
Capacity range (per regulation):
- OSHA & CSA: 100 - 310 lbs.
- ANSI: 130 - 310 lbs.
A S O N D
Min. setback distance from edge: 0'
Max. arresting distance: 54" - 102''
Free fall: 6' max.
Fall clearance: 17' - 21'
(Non-LE Use):
Capacity range (per regulation):
- OSHA: 100 - 420 lbs.
- ANSI: 130 - 420 lbs.
- CSA: 100 - 310 lbs.
Max. arresting distance: 54"
Date of First Use
Free fall: not permitted
Fall clearance: 9'
91175 (Rev. A)
Class B SRL
2
WARNING: Follow all
manufacturer's
instructions included
at time of shipping.
AVERTISSEMENT :
Suivre toutes les
instructions du
fabricant fournies
avec le produit lors
de sa livraison.
3
WARNING: This device
shall be removed from
service when the
visual load indicator
is deployed.
AVERTISSEMENT : Ce
produit doit être retiré
du service lorsque
l'indicateur de chute
est activé.
4
WARNING:
Leading edge device.
AVERTISSEMENT :
Dispositif conçu
pour les bords
coupants.
85399 (Rev. B)