Activate Flash Mode By Hardware - Peak PCAN-MicroMod FD User Manual

9. Leave Embedded Firmware selected it it is suitable for the firmware update.
Alternatively:
Select Firmware File and then browse for the *.bin file to be flashed.
10. Click on Next and check the provided information on panel 4 of PEAK-Flash.
11. Click on Start and observe the log output.
During the flash process the Run LED on the MicroMod FD device is blinking
quickly in orange color. The flash process is running for about 30 seconds.
12. In PEAK-Flash, Click on Reset Module.
The MicroMod FD device is now ready for use with the new firmware.

6.4 Activate Flash Mode by Hardware

If the MicroMod FD device cannot be set to Flash mode via PEAK-Flash, this can be
done alternatively by hardware.
Do the following to activate the flash mode by hardware:
1. Disconnect the left 10-pin mating connector for the basic supply.
2. Make a connection between pin 1 Ub and pin 7 Boot on the mating connector.
3. Reconnect the mating connector to the MicroMod FD device and thus also
reconnect the power supply.
The Activity LED blinks quickly orange and indicates that the flash mode for
CAN is active.
4. After utilizing the Flash mode, remove the connection between pins 1 and 7 so
that the MicroMod FD device runs in normal operation mode after a restart.
6 Firmware Update PCAN-MicroMod FD Analog 1
User Manual 1.2.0 © 2021 PEAK-System Technik GmbH
19