Peak PCAN-MicroMod FD User Manual page 12

To open the casing and remove the circuit board:
Attention! Electrostatic discharge (ESD) can damage or
destroy components on the circuit board. Take precautions to
avoid ESD when handling the circuit board.
1. Remove the mating connectors from the device.
2. On one connection side of the casing, remove the two screws to the right and
left of the connector and remove the plate including the rubber sleeve.
3. Pull the board out of the side of the casing.
4. For later assembly, proceed in reverse order.
Do the following to set the device ID:
1. Set the rotary switch next to the 10-pole connector J1 to the desired device ID
(0 to 15, with positions A to F corresponding to numbers 10 to 15).
Note: A changed device ID only takes effect after the PCAN-
MicroMod FD Analog 1 has been restarted.
4 Optional Hardware Settings
User Manual 1.2.0 © 2021 PEAK-System Technik GmbH
PCAN-MicroMod FD Analog 1
12